PPR glass tube or pipe extrusion machine / production line(75mm-160mm) is used to produce PPR glass tube or pipe pipe with 75mm - 160mm diameter.

PPR glass tube is three layer pipe,its feature:

1. Linear expansion coefficient is only about 20 to 30% of the normal pp-r products;Thoroughly solved the plastic pipe flexible problems.

2. The stiffness is stronger, no pipe droop,less fixed point.All of these feature reduce the engineering cost.

3. Proof pressure is higher,has a longer service life in the shaking force.

4. Better high temperature resistance,normal work temperature can reach 95-100

5. Under the same level of pressure,PPR - GRP - PPR has a thinner wall and larger pipe diameter,so there is larger water-carrying capacity.

6. Good sealing,no water moss,no oxygen permeability,so it could keep fresh pure water quality.

PPR glass tube pipe extrusion machine extrusion machine / production line(75mm-160mm) production:

PPR glass tube or pipe extrusion machine / production line(75mm-160mm)Introduction:

1. Total installed power: 180Kw, 380 V three phases+N+G, 50HZ

Load factor: 55%-80%  (Actual power is 140kw)

2. Cooling circulars water:10 m3/h

3. Compress air:0.3m3/min

4. Workhouse: 50000×2300×2600mm(length, width and high of line)

5. Products dimension: 75mm-160mm

6. Output: 250kg/hour

PPR glass tube pipe extrusion machine extrusion machine / production line ( 75mm-160mm) machinery specification:

All the PPR glass pipe production line:

1. Automatic Feeder and drying hopper

2. Single Screw Extruder 65 / 33 ( Middle layer of GRP ) 1set

   Single Screw Extruder 65 / 33 ( Inner and out layer of PPR ) 1set

3. Mark line extruder SJ 25 / 25

4. PIPE molds

5. Vacuum sizing tank

6. Spray cooling tank

7. Printer

8. Belt haul-off

9. Non scrap Cutting unit

10. Stacker

11. Digital control cabinet

Technology and Service:

1. Seller supply full set of technical document, cutter and other full document (write in English).  

2. Seller supply training for buyer’s staff until buyer can produce the eligible production independently.  

3. Seller is responsible for installing, testing, adjusting and debugging the machines in buyer’s factory.

4. Buyer should pay the expense for our engineers including for our engineer including round-

way tickets, inland traffic, lodging and boarding fee when the machine is installed, tested and maintained.

5. Seller will go to install machines after the machine is arrived at buyer and buyer will have prepared all 

conditions (including power, water, compress air, tools and materials for producing pipe, etc) for installing 

and testing these machines. Buyer should pay 60USD/day.

6. When installing,people of both sides cooperate well and carefully,buyer supplies convenient working 

condition,any problem, should discuss peacefully and kindly.

7. Buyer supply proper working tools, equipments and other conditions.

8. The expense including the accommodation and materials of the trial-

run the machine for testing and other expenses(electric, water, air and worker) will be on seller’s account,

 if the buyer or their representatives do the inspection of the machines before shipment.

9. Guarantee period: 14 months after shipment (the date of B/L)